ROUTERPOF 1300GB / IE / CY Operation and Safety Notes Page 5Kompernaß GmbH Burgstraße 21 D-44867 Bochum (Germany)Last Information Update: 10 / 2007
12 GB/IE/CYPreparing for usesurfaces, slots for letters or butt jointed connections, notches, tongue and groove joints etc.Cove cutter bit / cove cut
13 GB/IE/CYPreparing for use / OperationQ Attaching the vacuum extraction adapter (with reducer piece) m Warning: Always pull the mains plug is out
14 GB/IE/CYOperationQ Setting the depth of cutm Danger! Set the cutting depth only after the device has been switched off!Coarse setting of the dept
15 GB/IE/CYOperationj Tighten the stop screw 9 for depth stop 10 again.j Release the clamping lever 15 by turning it clockwise and then guide the
16 GB/IE/CYOperation / Maintenance and cleaning / Disposalj Place the guide fence 27 against the edge of the workpiece. Now carry out the fine adjus
17 GB/IE/CYInformationQ InformationQ Service centreThe service centre for your country is shown in the warranty documentation.J Have your device r
18
BA12345672389131415161012111718 1920212224 25C DE FG H26 3237343335 3631 30272829
5 GB/IE/CYTable of contentIntroductionProper use...
6 GB/IE/CYIntroductionRouter POF 1300Q Introduction Please make sure you familiarise your-self fully with the way the device works before you use
7 GB/IE/CYIntroduction14 Fine adjustment knob for depth of cutFigure B, rear of device:15 Clamping lever 16 Markings for zero-reset17 Lights for c
8 GB/IE/CYIntroduction / Safety adviceSafety adviceJ Attention! In order to protect yourself from the danger of electric shock, injury or fire when u
9 GB/IE/CYSafety adviceDamaged or tangled mains leads or plugs in-crease the risk of electric shock.J A damaged tool, mains lead or plug presents a
10 GB/IE/CYSafety adviceJ Keep cutting tools clean and sharp. Carefully maintained cutting tools with sharp cutting edg-es are less likely to jam a
11 GB/IE/CYSafety advice / Preparing for useconcealed cable or the device’s mains lead. Contact with an electrical lead or cable means that the metal
Comments to this Manuals